|
ORIGINAL ADAPTER |
1.This is the most common style of fan for using the Grease Trap original
fan adaptor.  |
2. Locate the drain hole on the exhaust fan. |
3. Center the adaptor over the drain hole. |
4. Install the screws in the adaptor and fan. Do not
over tighten. |
5. Wet the inside of the hose and slide it on the
adaptor. |
6. Tighten the hose clamp.  |
7. Remove the plastic from the pail. |
8. Remove the plastic covering the lid hole. |
9. Measure the hose leaving an additional 2 inches to
insert into the pail.  |
10. Cut the hose. |
11. Insert the hose into the pail. |
12. All done. |
